New Serial Protocol for the VAG Group: BOSCH MD1CS0xx / MD1CP0xx ECUs Now Supported
An important update has arrived for the VAG group: identification and serial writing are now available for BOSCH MD1CS0xx and MD1CP0xx ECUs via the FLASH_0797 protocol.
This solution allows ECU reprogramming directly via the diagnostic port – no need for BENCH mode.
We strongly recommend reading the dedicated user manual carefully before proceeding.
Compatible ECUs:
Specifically, you can now work on the following ECUs:
-
MD1CP004 with SPC5777M microprocessor
-
MD1CP004 with TC298TP microprocessor
-
MD1CP014 with TC298TP microprocessor
- MD1CS014 with TC299TP microprocessor
-
MD1CS004 with TC298TP microprocessor (excluding variants with H80 hardware)
This solution applies to a wide range of VAG group vehicles already supported by previous protocols – a step forward for those seeking operational efficiency and maximum compatibility in serial calibration.